AVSPLIM02

The AVSPLIM01 Speed Sensing Module is designed to turn OFF certain pieces of electronic equipment, whereas the AVSPLIM02 Speed Sensing Module is designed to turn ON certain pieces of electronic equipment above given speeds to eliminate confusion to the vehicle operator and nuisance to the general public.

Dual voltage 12-24V
Waterproof and dustproof
Multi-setting speeds available
Compatible with most quality manufactured products
Ideally suited to front or side sensor systems, the unit will disengage sensor systems when the vehicle is travelling over a certain speed.

It has been specifically designed for use with our range of Indicator Alarms and Indicator Alarmalights®.

The unit is completely versatile and can be used for any electronic device where working at or below certain speeds is an issue.

The unit is completely encapsulated so it can be fitted inside the cab or outside and has a handy mounting bracket for ease of fitting.

Fitting of Speed Limiter

The device is designed to turn OFF (AVSPLIM01) / ON (AVSPLIM02) our indicator Alarmalight® at a predetermined speed, which is set by selecting various options on the dil switch as set out in the fitting instructions.

The unit needs to be powered directly from the vehicle; RED is positive and BLACK is ground.

There are 3 tab terminals in the unit, marked on the fitting instructions:

Speed in – on the bottom right this needs to be connected to plug B, Pin 8 on the back of the Tachograph and it will give the input signal to operate the unit.
Output – this would be connected to the green lead from the Indicator Alarmalight to Activate it at the required speed.
Override – this is generally NOT used for the Indicator Alarmalight as it is used more commonly for frontsensors it can be connected to either a switch on the dashboard or the handbrake as it means the vehicle is not moving therefore the Indicator Alarmalight or Front Sensors do not need to be active, as it would cause confusion.
This unit will not affect the can bus system on vehicles.